Initial Operation Of The Switching Holder - Weller WDH 10T Mode D'emploi

WDH 10T/20T
WARNING!
4.1 Technical data WDH 10T/20T
Dimensions
Weight
Matching soldering tools
Connectable
control units

5 Initial operation of the switching holder

Risk of burns when working with soldering tools and
risk of suffocation when working with inert gases.
There is a risk burning if you touch the hot soldering tool. When
working with inert gases, e.g. with the WSP 80IG, there is a risk of
suffocation.
Always deposit the soldering iron in the switching holder.
When using inert gases, ensure that room ventilation is
adequate!
If not used for long period, depressurise the pressure
connection (2) of the device.
1. Carefully unpack the switching holder.
2. Ensure that the soldering station to be connected is switched off.
3. Insert the 7-pin connector (3) of the connecting cable at the
soldering station and lock it..
4. Deposit the soldering iron (9) in the switching holder (1) and
insert in the 7-pin pushing (8) and lock..
5. Switch on the soldering station (7).
To operate the switching holder with the inert gas soldering iron
WSP80 IG, control unit WAD 101 is required. Observe the Operating
Instructions of your control unit when doing this.
L x W x H (mm): 208 x 65 x 115
L x W x H (inches): 81.89 x 2.56 x
4.53
0.69 kg
− WDH 10T: WSP 80, WSP 81,
WP 80, WSP 80IG
− WDH 20T: WMP
WSD 81, WSD 161, WSD 151,
WSD 151R, WDD 81V, WSL, WSL 2,
WAD 101, WMRS, WMD 1S,
WMD 3, WD 1, WD 2, WD1 M,
WD 2M, WR 3M
5-8