WMF LINEO Mode D'emploi page 15

Insert paper filter and place the pot in the machine. Place one dose of (125 ml)
durgol® universal into the water tank and fill with tap water to the 10-cup mark
(version with glass pot) or to the 8-cup mark (version with vacuum jug).
To start the descaling, press the button and hold this down for approximately 4
seconds. CALC appears in the display, the descaling program starts automatically and
the illuminated ring for the start / stop button illuminates. The descaling program
ends automatically after approximately 40 minutes, the illuminated ring of the start
/ stop button turns off and the display shows the time again.
Note: The device switches on and off several times during the descaling process.
Important: Afterwards, fill the tank to the 10-cup mark (version with glass pot) or
to the 8-cup mark (version with vacuum jug) with fresh tap water to rinse and run
the cycle once through.
Using vinegar or vinegar concentrate could damage materials in the appliance.
When using descalers with citric acid bases, deposits could form during descaling
that seal the limescale layer or clog the lines in the device. In addition, descaling
with citric acids runs too slowly. A complete descaling process can therefore not be
guaranteed.
Attention: there is no claim under warranty for damages caused by not observing
the descaling instructions.
Cleaning
Unplug the mains plug and allow the appliance to cool down.
Do not immerse the device in water, but rather clean the outside with a damp cloth
15