Additional Safety Instructions - WMF LINEO Mode D'emploi

Technical data
Rated voltage:
Power consumption:
Power consumption:
Protection class:

Additional safety instructions

▪ Only connect the device to properly installed earthed sockets. The wire and plug
must be dry.
▪ Do not pull the connecting cable over sharp edges or clamp it. Do not let it hang
down and protect it from heat and oil.
▪ Only use extension cords that are in perfect condition.
▪ Never disconnect the mains plug from the socket by the cord or with wet hands.
▪ Do not carry the device by the cord.
▪ Do not place the coffee machine on hot surfaces, such as hot plates or similar, or
near open flames. The housing could melt.
▪ Do not place the device on water-sensitive surfaces. Water spray may damage
them.
▪ Do not switch on the device without water. Fill the fresh water tank with cold
water only to the maximum possible number of cups at the most.
▪ Do not put any water in the device if it is switched on or still hot. Prior to filling,
switch the coffee machine off and allow to cool for five minutes.
▪ Caution, the device is hot. Risk of scalding from escaping steam. Never swing the
filter out or open the cap during operation.
▪ If the device will not be used for some time, disconnect the mains plug.
▪ Stop using the appliance and/or connect it from the mains plug immediately if:
⋅
The appliance or mains cable is damaged
⋅
There is any suspicion of a fault after dropping the appliance or similar.
In such cases, send the appliance to be repaired.
▪ Only operate the device under supervision.
▪ Descale the device regularly.
▪ The vacuum jug is not suitable for the microwave.
▪ The glass pot is not suitable for the microwave.
▪ No liability is assumed for damages in cases of misuse, improper operation, non-
observance of the descaling instructions or unprofessional repairs. Claims under
warranty are likewise excluded in such cases.
Start-up
Prior to first use and after the device was not used for a long period of time, run a
cycle through with fresh water and no ground coffee. To do so, fill the tank to the
10-cup mark (version with glass pot) or to the 8-cup mark (version with vacuum
jug), as otherwise the pot can overflow.
Setting the current time
After connecting the mains plug to a socket, the display shows the time and Set.
Set the current time by pressing the h and min buttons. To advance the time quickly,
you can hold down the h or min buttons. Confirm by pressing the Set button.
As long as you do not confirm the time by pressing Set, the set time will blink.
Note: You can also brew coffee immediately after connecting the mains plug to a
socket by pressing the start / stop button briefly.
220-240 V~ 50/60 Hz
960 W (version with glass pot)
900 W (version with vacuum jug)
I
11