Operating The Multicooker - Redmond RMC-M13A Manuel De L'utilisateur

II. OPERATING THE MULTICOOKER
Before Operating
Place the device on a flat, stable, and hard surface away from any objects
or cabinets that could be damaged by steam, humidity, or high tempera-
tures.
Before operating, make sure that the outer and inner parts of the multi-
cooker have no dents, cracks or any other visible damages. There should
not be any obstructions between heating element and the bowl.
Standby Mode
After you connect the appliance, it enters standby mode and displays
current time in 24-hour format.
During program adjustment, if no buttons are pressed within a minute
the device automatically enters standby mode.
Setting the Clock
1. Press and hold down the HOUR/MIN button in standby. The display
shows indicator, TIMER starts flashing.
2. Turn the control knob clockwise to increase and counterclockwise to
decrease the hour value. When the maximum value is reached, the
appliance goes back to the minimum value.
3. Press HOUR/MIN to adjust the minutes. The minute value indicator
starts flashing. Turn the control knob clockwise to increase and
counterclockwise to decrease the minute value. When the maximum
value is reached, the appliance goes back to the minimum value.
4. To save the current time do not press any button for a few seconds.
To Enable/Disable Audible Signals
The audible signals confirm that the button has been pressed and that
the cooking cycle is complete. To disable the audible signals press and
hold down CANCEL in standby mode. To reactivate audible signals, repress
CANCEL.
Non-volatile Memory
The Multicookers REDMOND RMC-M13A/M23A/M33A are equipped with
a non-volatile memory unit. In case of a power shortage (including the
cycle interruption for up to 15 minutes), the appliance resumes its op-
eration without any memory loss.
NOTE! If you do not want to resume the process press CANCEL. The ap-
pliance switches to standby.
To Adjust Cook Time
You can adjust the default cook time. The time adjustment range and
interval depend on the program selected.
1. Turn the control knob to select a program. The TIMER indicator lights up,
the default time is displayed.
2. Press SET. The hour value indicator starts flashing.
3. Turn the control knob clockwise to increase and counterclockwise to
decrease the hour value. When the maximum value is reached, the
appliance goes back to the minimum value.
4. Press HOUR/MIN to adjust the minutes. The minute value indicator
starts flashing. Turn the control knob clockwise to increase and
counterclockwise to decrease the minute value. When the maximum
value is reached, the appliance goes back to the minimum value.
Cook time in PANCAKE, RAVIOLI, PASTA, and CRUST starts to count
down after the appliance reaches its operating temperature; in the
STEAM program the countdown starts only when water comes to a full
boil, providing enough steam.
To switch between Fahrenheit / Celsius
Your Multicooker can switch from Fahrenheit to Celsius and from Celsius
to Fahrenheit:
1. Press the SET button twice. "212" and the °F indicator are blinking.
2. To switch to Celsius press and hold REHEAT for 3 seconds "100" and
the °C indicator are blinking.
3. To switch back press and hold REHEAT for 3 seconds.
4. Turn the control knob to set the temperuture.
5. To save the adjustment do not press any button for three seconds.
RMC-M13A, RMC-M23A, RMC-M33A
(in MULTICOOK)
ENG
9 9