Redmond RMC-M13A Manuel De L'utilisateur page 11

3. Close the lid until it clicks into place. Plug in the appliance.
4. Turn the control knob to select a program. The Selected program
indicator starts flashing, the TIMER indicator and the default time are
displayed.
5. Press SET and adjust the time. In MULTICOOK, repress SET to adjust
the temperature. The temperature indicator starts flashing. Turn the
control knob to select the temperature required. Turn clockwise to
increase and counterclockwise to decrease the temperature value.
When the maximum value is reached, the appliance goes back to the
minimum value.
6. Delay the program if necessary.
7. Press START/KEEP WARM. The button indicator lights up, the cycle
begins, and TIMER starts to count down.
8. After the cycle is complete an audible sound is heard, the program
indicator goes off. Depending on your settings the device either enters
KEEP WARM (the KEEP WARM indicator lights up, KEEP WARM time
starts to progress) or standby.
9. To interrupt the cycle, to cancel the program, or to disable the KEEP
WARM function, press CANCEL.
MULTICOOK Program
The program can be used to cook any dish with your own time and tem-
perature settings. Default time is 30 minutes. It can be adjusted from
2 minutes to 12 hours in 1 minute intervals.
You can manually set 28 temperature adjustments from 95°F (35°C) to
340°F (170°С). Default temperature is 212°F (100°С).
QUICK COOK Program
The program is recommended for quick-cooking rice and other types of
grain. The temperature and time cannot be adjusted; KEEP WARM and
TIME DELAY are not applicable.
• Follow steps 1-3 of the "Standard Operating Procedure for Automatic
Programs".
• Use the control knob to select QUICK COOK (the program indicator
starts flashing, «––––» is displayed).
• Press START/KEEP WARM. The button indicator lights up, the cycle
begins. The Progress bar indicator is displayed.
• After the cycle is complete an audible sound is heard, the program
indicator goes off. The appliance switches to standby.
• To interrupt the cycle or to cancel the program press CANCEL.
RICE/GRAINS Program
The program is recommended for cooking rice and different types of grain.
Default time is 25 minutes. It can be adjusted from 5 minutes to 4 hours
in 1 minute intervals.
STEAM Program
The program is recommended for steaming meat, fish, vegetable, seafood,
etc. Default time is 30 minutes. It can be adjusted from 5 minutes to
2 hours in 5 minute intervals.
The countdown starts after water comes to a full boil providing enough
steam.
• Fill the bowl with 2 ½ - 4 cups (600-1000 ml) of water. Place the steam
tray inside the bowl.
• Measure ingredients according to the recipe, evenly distribute them
inside the tray. Position the bowl inside the appliance and slightly
rotate it from side to side to ensure that it makes full contact with the
heating element.
• Follow steps 3-8 of "Standard Operating Procedure for Automatic
Programs".
BOIL Program
The program is recommended for boiling meat, fish, and vegetables.
Default time is 45 minutes. It can be adjusted from 10 minutes to 8 hours
in 5 minute intervals.
SOUP Program
The program is recommended for making different types of soup. Default time
is 1 hour. It can be adjusted from 10 minutes to 8 hours in 5 minute intervals.
RMC-M13A, RMC-M23A, RMC-M33A
ENG
11 11