Guide lines to bacteria control and other dangers coming from the presence of microbes in the DustGuard™
system (optional).
WARNING!
To prevent the operators and other people from developing infections caused by microbes and Legionella that
may flourish in the dust guard system, take the following precautions:
–
If possible, fill the tank with cold water (< 20 °C).
–
DO NOT use stagnant water to fill the tank.
–
DO NOT use recycled water, undrinkable water or water that has been in contact with the soil.
–
Adjust and turn the nozzles towards the floor only, from preventing possible inhaling.
–
Do not store the machine outdoors or near sources of heat.
–
Do not over-fill the tank. Fill the tank sufficiently so that it can be emptied by using the system.
–
Empty the tank every 10 hours or once a week, according to the use.
–
If the machine is not used for more than one week, empty the tank completely, and let it dry.
–
If the tank cannot be cleaned regularly, consider using a biocide that can kill or exert a controlling effect on
Legionella bacteria. Biocide must be chosen according to the local regulations and must be used according
to the relevant instructions and cautions, to avoid that the personnel gets affected by dangerous chemical
substances.
–
If chemical products have to be used in the water tank, it is mandatory to apply the relevant information and
caution labels of the product.
MACHINE DESCRIPTION
MACHINE STRUCTURE
1.
Steering wheel
2.
Control panel (see the following paragraph)
3.
Driver's seat with safety microswitch
4.
Seat position adjusting lever
5.
Drive pedal
6.
Service brake pedal
7.
Parking brake lever: press both the service brake (6) and
the lever (7) to switch from the service brake to the parking
brake
8.
Front skirt lifting pedal
9.
Release lever for hopper discharge
10. Rear hood with vacuum system
11. Hopper (empty it when it is full)
12. Right door (to be opened for performing maintenance
procedures only)
13. Left door (for main broom removal)
14. Right side broom
15. Left side broom (optional)
16. Side broom guards (optional)
17. Main broom
03/2013
INSTRUCTIONS FOR USE
18. Engine compartment hood
19. Can holder
20. Rear wheels
21. Front driving and steering wheel
22. Dust filter container
23. Panel filter with filter-shaker
24. Steering column or water tank for dust guard system
(optional)
25. Dust guard system water filler neck plug (optional)
26. Dust guard system nozzles (optional)
27. Working lights (optional)
28. Flashing light (always on when the ignition key is turned to
"I")
29. Safety belt (optional)
30. Serial number/technical data/conformity certification plate
31. Anchoring slots for transport (not for lifting)
32. Fuel tank (Petrol)
33. Filler plug (Petrol)
34. Fuel opening/closing valve (Petrol)
35. Hopper manual returning handle
1464815000 - SW4000, FLOORTEC R 870
ENGLISH
7