Bosch HDS Notice D'installation page 10

6. Carefully tip range forward pulling from the back
to ensure that the anti-tip bracket engages the
range leg and prevents tip-over.
rigid Pipe method
elbow
nipple
union
nipple
elbow:
connect to
regulator here
Gas Flow to Range
The configuration of the rigid pipe connection will
vary depending on the location of the gas pipe stub.
Refer to figure above for details.
10
gas shut off valve
elbow
nipple
1/2" to 3/4"
gas pipe
,
cautIon
Before you plug in an electrical cord, be sure all con-
trols are in the OFF position.
1. Make sure circuit breaker is off and then plug
range cord into electrical outlet.
2. Slide range into position ensuring that the left
back leg slides under the anti-tip bracket. Range
will sit 3/4" (19 mm) away from back wall when
properly installed.
3. Carefully tip range forward pulling from the back
to ensure that the anti-tip bracket engages the
range leg and prevents tip-over.
4. Connect pipe to range at union. Access the con-
nection through the access panel behind the
warming drawer.
note: Be careful not to apply pressure to warming
drawer element during rigid pipe installation.
** Teflon is a registered trademark of DuPont