Promise Technology VTRAK M610p Guide De Démarrage Rapide page 17

Step 8: Creating Disk Arrays with WebPAM PROe
Set up with WebPAM consists of the following:
• Log-in to WebPAM PROe (below)
• Selecting a Language (page 19)
• Creating a Disk Array (page 19)
• Logging out of WebPAM PROe (page 23)
Logging into WebPAM PROe
1. Launch your Browser.
2. In the Browser address field, type in the IP address of the VTrak subsystem.
Use the IP address you obtained in Step 7 (see page 13). Note that the IP
address shown below is only an example. The IP address you type into your
browser will be different.
Regular Connection
• WebPAM uses an HTTP connection . . . . . . . . . . . . . . . . . . . . .http://
• Enter the VTrak's Management Port IP address . . . . 192.168.1.105
Together, your entry looks like this:
http://192.168.1.105
Secure Connection
• WebPAM uses a secure HTTP connection . . . . . . . . . . . . . . .https://
• Enter the VTrak's Management Port IP address . . . . 192.168.1.105
Together, your entry looks like this:
https://192.168.1.105
You can also use the CLU to create disk arrays and logical drives.
See Chapter 5 of the VTrak Product Manual on the software CD
for more information.
Whether you select a regular or a secure connection, your login to
WebPAM and your user password are always secure.
Step 8: Creating Disk Arrays with WebPAM PROe
Note
Note
17