Sirius SILT18 Instructions D'utilisation Et Avis De Montage page 10

WARNINGS
* The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be su-
pervised to ensure they do not play with
the appliance.
* The cooker surface and the inferior part
of the cooker hood must be at a minimun
distance of 65 cm.
If the rating lable in the cooker-hood
shows the symbol
built in class II° and it does not need any
earth connection.
If the rating lable in the cooker-hood does
not show the symbol
built in class I° and it needs the earth con-
nection.
* When performing the electrical connections
on the appliance, please make sure that the
current-tap is provided with earth connection
and that voltage values correspond to those
indicated on the label placed inside the ap-
pliance itself.
* Before carrying out any cleaning or main-
taining operations, the appliance needs to
be removed from the electric grid. If the ap-
pliance is not provided with a non-separable
flexible cable and plug, or with another de-
vice ensuring omnipolar disconnections from
the grid, with an opening distance between
the contacts of at least 3 mm, then such di-
sconnecting devices must be supplied within
the fixed installation.
If the fixed appliance is endowed with a sup-
ply cord and a plug, the appliance has to be
put in a place where the plug can be reached
easily.
* The use of materials which can burst into
flames should be avoided in close proxi-
mity of the appliance. When frying, please
pay particular attention to fire risk due to
oil grease. Being highly inflammable, fried
oil is especially dangerous. Do not use un-
covered electric grills.
, the appliance is
, the appliance is
In order to avoid possible fire risk, all in-
structions for grase-filter cleaning and for
removing eventual grease deposits should
be strictly followed.
The appliance can only be used in the filte-
ring version, so it is equipped with metal gre-
ase filters and activated charcoal filters.
INSTALLATION
Make sure that the packaging is in perfect
conditions and that none of the components
inside is damaged : in case of damaged com-
ponents, please contact your retailer and do
not carry out installation.
Read all of the following instructions before
carrying out installation.
SILT18 Installation
Place the fixing plate (Fig.1) in the ceiling,
connected with the centre of cook-top , drill
the holes and fix the plate using the screws
and screw anchors supplied with the applian-
ce.
The power cord must pass through the plate
hole shown by the arrow in Fig.1.
Take the cylindrical support rod from inside
the packaging and cut it accordingly to the
ceiling height , assuring a distance of from
the cook-top to the lowest part of the coo-
ker-hood. .
*Caution: the rod side where holes are pre-
sent must not be cut.
Remove the chromium plated cover from the
cooker-hood (see fig.2), then fit the support
rod and fix it by tightening the related nut
(Fig.3). Pay special care in adjusting the sup-
port rod in vertical position.
Insert the power cord into the support rod
until it comes out from the slot placed in the
upper side of the rod.
10
USES