Troubleshooting Guide - Metabo HPT C 10FCG Mode D'emploi

English
• To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source before making any adjustments.
• All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact metabo HPT Authorized Service Center.
GENERAL
PROBLEM
Saw will not start.
Saw makes unsatisfactory cuts.
Blade does not come up to speed.
Saw vibrates excessively.
Does not make accurate miter cuts.
Material pinches blade.
16

TROUBLESHOOTING GUIDE

WARNING:
PROBABLE CAUSE
1. Saw not plugged in.
2. Faulty switch.
3. Fuse blown or circuit breaker tripped.
4. Cord damaged.
5. Worn, broken brushes.
1. Dull blade.
2. Blade mounted backwards.
3. Gum or pitch on blade.
4. Incorrect blade for work being done.
1. Extension cord too light or too long.
2. Low supply voltage.
1. Blade bolt not tight.
2. Saw not mounted securely to workbench.
3. Workbench on uneven fl oor.
4. Blade or blade fl anges not clean.
1. Damaged saw blade.
2. Positive stop not adjusted correctly.
3. Workpiece moving.
1. Cutting bowed material in wrong position.
REMEDY
1. Plug in saw.
2. Have switch replaced by an Authorized Service
Center.
3. Replace fuse or reset circuit breaker.
4. Have cord replaced by an Authorized Service
Center.
5. Replace brushes.
1. Replace blade.
2. Turn blade around.
3. Remove blade and clean with turpentine and
coarse steel wool.
4. Change the blade.
1. Replace with the adaquate size extension cord.
2. Contact the electric company.
1. Tighten blade bolt.
2. Tighten all mounting hardware.
3. Reposition workbench on fl at level surface.
4. Clean blade and blade fl anges.
1. Replace blade.
2. Check and adjust positive stop.
3. Clamp workpiece securely to fence.
1. Position bowed material correctly (convex side
to the back fence).