Fm Radio Operation - Krüger & Matz KM1598D Mode D'emploi

Owner's manual
Dynamic label segment is a scrolling message that the broadcaster may
include with their transmissions. The message usually includes information,
such as programme details etc.
• Signal Strength
This shows a number to indicate the signal strength which is between 0 and
100, for example 15, 80 or 100. The stronger the signal, the greater the number.
• Programme Type
• Frequency
• Stereo/Mono

FM RADIO OPERATION

Note:
• Before operating the radio, please check that the antenna is correctly
connected and adjusted for length and direction.
• You can program a maximum of 20 FM radio stations
Tuning in to a Station
1. Rotate the SOURCE knob on the unit or press the FM/DAB button on the
remote control to select tuner source.
2. Select a station using one of the following methods.
• Auto Tuning
Press and hold the
until a station is found.
• Manual Tuning
Repeatedly press the
station you want.
• Preset Tuning (Available only after the stations are preset)
Repeatedly press the PRESET
desired preset number. Its band and frequency are displayed on the front panel.
Program radio stations
• Automatically
Press and hold the PROGRAM button on the remote control to activate
automatic program mode. [SCANING] is displayed. The unit stores all the FM
radio stations automatically and then broadcasts the first preset radio station.
• Manually
1. Tune to the desired station:
2. Press the PROGRAM button on the remote control to activate program
mode.
3. Press the PRESET / buttons on the remote control to select the preset number.
/ button, the frequency changes down or up automatically
/ buttons to change the frequency until you find the
/
buttons on the remote control to select the
35