Technical Specifications - Hama 00210592 Mode D'emploi

Note – Power Delivery / QC 3.0, 2.0
• Plug & go: No manual setup necessary, just
connect and start:
Voltage and power are automatically
configured by Power Delivery / QC 3.0, 2.0.
• For efficient and optimised charging, the Power
Delivery (PD) / QC 3.0, 2.0 function must be
supported by your terminal device.
• With the large quantity of PD / QC-enabled
terminal devices with different firmware
versions, it can happen that the function is not
fully supported.
Warning
• Only connect the product to a socket that has
been approved for the device. The socket must
be installed close to the product and easily
accessible.
• Disconnect the product from the network using
the power button – if this is not available,
unplug the power cord from the socket.
• When using a multi-socket power strip,
make sure that the sum power draw of all
the connected devices does not exceed its
maximum throughput rating.
• If you will not be using the product for a long
period of time, disconnect it from mains power.
Unless the operating instructions for the devices
you want to charge explicitly inform you otherwise,
proceed as follows:
• Connect your terminal device to a USB charging
socket using a suitable USB cable.
• Connect the charger to a properly installed and
easily accessible power socket.
• Charging progress is displayed on your terminal
device.
• Disconnect the terminal device from the charger if
you want to interrupt charging or if the terminal
device is fully charged.
• Then disconnect the charger from the mains.
When charging batteries built into a device, pay
attention to the maximum charging time for the
batteries.
5. Care and Maintenance
Only use dry, soft cloths for cleaning.
Note
Disconnect the device from the power supply
before cleaning or if it will not be used for a long
period of time.

6. Technical specifications

Specifications in accordance with
Regulation (EU) 2019/1782
Manufacturer's
name or trade mark,
commercial registration
number and address
Model identifier
Input voltage
Input AC frequency
Output voltage /
Output current /
Output power
Average active efficiency
Efficiency at low load
(10 %)
No-load power
consumption
Note
• If only the USB-C socket is used, the maximum
power output from this socket is 65 W.
• If the USB-A and the USB-C socket are used
at the same time, the maximum power output
from the USB-C socket is 45 W, and from the
USB-A socket it is 18 W.
Hama, HRA12159,
Dresdner Str. 9,
86653 Monheim
00210592
100 – 240 V
50 / 60 Hz
USB-C Total: 65.0 W
USB-C:
5.0 V DC / 3.0 A/ 15.0W
9.0 V DC / 3.0 A/ 27.0W
12.0 V DC / 3.0 A/ 36.0W
15.0 V DC / 3.0 A/ 45.0W
20.0 V DC / 3.25 A/ 65.0W
USB-A:
3.6 -6.0 V DC / 3.0A/
10.8W-18.0W;
6.0 - 9.0 V DC/ 2.0 A/
12.0W-18.0W;
9.0 - 12.0 V DC / 1.5 A/
13.5W-18.0W;
USB-C + USB-A:
45.0 W + 18.0W
(Total: 63.0W)
88.6 %
82.6 %
0.14 W
3