Adding A Monitor - SOMFY V100 Notice D'installation

EN
Your installation may include a maximum of two indoor monitors.
Disconnect the power adapter from the monitor which has already been installed before adding the new monitor.
[1]. Secure the additional monitor mounting plate to the wall.
Important: Ensure the direction of fitting is correct by positioning the arrow upwards ("UP" facing upwards) as indicated on the illustration.
Note: You can also use the mounting screws provided in standard flush-mounting boxes; the distance between the plate mounting holes is the same.
[2]. Remove the DC connector from the rear of the additional monitor and connect the cable from the power adapter provided to this connector: black wire
with white lines on the left (+) and black wire on the right (-).
[3]. Connect the power adapter connector to the DC input at the rear of the additional monitor in the direction indicated in the illustration (screws at the
bottom); the direction in which the power adapter wires are connected is important.
Important: It is essential to use the power adapter provided to supply the monitor.
[4]. Important: The distance between the two monitors must not exceed 30 m. Use a 2-wire cable with a minimum cross-section of 0.5 mm².
Connect the additional monitor (Monitor 2) to the existing monitor (Monitor 1) using the existing P2 connectors at the rear of the monitors, and respect
the connection direction:
- terminal M + of monitor 1 to terminal M + of monitor 2
- terminal M - of monitor 1 to terminal M - of monitor 2
[5]. Clip the additional monitor onto its mounting bracket by first positioning the top of the monitor on the station, then the bottom.
Note: Position the power adapter wires between the mounting bracket and the monitor.
1
3
Monitor 1
Monitor 2
Finish all of the cabling before connecting the monitor to
the mains.
3

3. ADDING A MONITOR

60 mm
To the door
station
2
4
V100 video entry phone
Power adapter
wires
Copyright © 2015 Somfy SAS. All rights reserved.