Standard Fittings; Optional Accessories - Comet STATIC 1700 Notice Technique

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Make sure that the following parts are included in the packaging of the purchased product:

• High pressure water cleaner.

• Hose reel complete with 10 m (

• Water gun.

• Spray gun hose.

• Rotating spray nozzle pipe (

• Foam spray nozzle.

• Rotating high water cleaning brush (

• Wall-mounting kit complete with securing nuts, screws and wall-plugs.

• Right and left safety hooks complete with stop rings.

• Wall-mounted accessory frame, complete with securing screws and wall-plugs.

• Hose reel handle.

• Handle complete with securing screws.

• Suction kit for use on walls, made up of gaskets, filter and quick-release fitting.

• Suction kit for use on the ground, made up of gasket and curved hose holder fitting.

• Instruction manual – Safety warnings.

• Instruction manual – Use and Maintenance.

• Guarantee certificate.

• Service centre booklet.

• Key for disassembling the nozzle.

• Nozzle cleaning pin.

If there are problems, contact your dealer or an authorised assistance centre.

The following range of accessories can be added to the standard high-pressure cleaner

equipment:

• Rotating spray nozzle pipe: designed to remove stubborn dirt.

• Sanding spray nozzle pipe: designed to sand down surfaces, to eliminate rust, paint settled

dirt etc.

• Rotating high pressure cleaning brush: designed to clean delicate surfaces.

• Fixed high pressure cleaning brush: designed to clean delicate surfaces.

• Hose purging probe: designed to unclog hoses and pipelines.

• Floor washing spray gun: designed to clean tiled floors and walls.

• Hose cleaning-guide kit: designed to wind-up the delivery hose easily and to clean it.

• Wheel kit: designed to make it easier to move the high pressure water cleaner around

when taken off the wall.

• 10 m extension kit of the delivery hose: designed to increase the reach of the high pressure

water cleaner.

• Insert the handle and press right down (2), then secure it with the two screws supplied

(35).

See FIG. 4.

• Insert the hose reel handle until it clicks into place (15).

• Screw the high pressure hose fitting on the thread of the water gun (24) and tighten firmly

with two 17-mm/0.67" fixed jaw spanners (not supplied).

• Insert the filter (18) in the water inlet fitting (17). Insert the gasket (26) in the quick-release

water inlet fitting (25) and screw it on tight onto the fitting (17).