Electrical Safety - Princess 142613 Mode D'emploi

Electrical safety

• Before use, always check that the mains
voltage is the same as the voltage on the
rating plate of the appliance.
• The appliance is not intended to be
operated by means of an external timer or
separate remote-control system.
• Connect the appliance to an earthed wall
socket. If necessary, use an earthed
extension cable of a suitable diameter
(at least 3 x 1 mm ).
2
• For additional protection, install a residual
current device (RCD) with a rated residual
operating current that does not exceed
30 mA.
• Make sure that water cannot enter the
contact plugs of the mains cable and the
extension cable.
• Always fully unwind the mains cable and
the extension cable.
• Make sure that the mains cable does not
hang over the edge of a worktop and
cannot be caught accidentally or tripped
over.
• Keep the mains cable away from heat, oil
and sharp edges.
• Do not use the appliance if the mains cable
or the mains plug is damaged or defective.
If the mains cable or the mains plug is
damaged or defective, it must be replaced
by the manufacturer or an authorised
repair agent.
• Do not pull the mains cable to disconnect
the mains plug from the mains.
• Disconnect the mains plug from the mains
when the appliance is not in use, before
assembly or disassembly and before
cleaning and maintenance.
Safety instructions for toasters
• Do not use the appliance outdoors.
• Place the appliance on a stable and flat
surface.
• Place the appliance on a heat-resistant and
splash-proof surface.
• Do not place the appliance on a hob.
• Do not cover the appliance.
• Make sure that there is sufficient space
around the appliance to allow heat to
escape and provide sufficient ventilation.
• Make sure that the appliance does not
come into contact with flammable material.
• Keep the appliance away from flammable
materials (curtains, table cloth), because
the bread can burn
• Keep the appliance away from heat
sources. Do not place the appliance on hot
surfaces or near open flames.
• Beware of hot parts. The surfaces marked
with a caution symbol for hot surfaces are
liable to become hot during use.
The accessible surfaces can become hot
when the appliance is operating. The outer
surface can become hot when the
appliance is operating.
• Always be careful when touching the
appliance. Use oven gloves if you need to
touch the appliance during or shortly after
use.
• Make sure that your hands are dry before
touching the appliance.
• Do not leave the appliance unattended
during use.
• Do not move the appliance while it is
switched on or is still hot. Remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter E or (earth symbol)
and is coloured GREEN or GREEN/YELLOW.
9