Recording And Listening Of Vocal Messages - Num'axes IKI VOICE Guide D'utilisation

Recording and listening of vocal messages

ATTENTION: to proceed to the recording or listening of the vocal messages, your collar must be
switched off.
When selecting the operating mode 2 or 3, you have to record 2 vocal messages of 5 seconds each. We
advise you to use short words and speak in a firm steadytone (without shouting).
Examples of messages: « no! » ; « stop! » ; « silence! »... which you can make follow or precede by the
name of your dog.
To record or listen your message 1, proceed in the following way:
- Remove the 2 screws from the battery cover with the supplied screwdriver.
- Remove the battery cover.
- Press and hold the button situated at the left side of the battery holder (See Diagram 6). A series
of beep sounds (from 1 to 4) will be emitted by the collar indicating the selected mode.
- Select the mode 3 : release the button when the mode 3 is reached.
- To record your vocal message 1, press again on the button and maintain the pressure during the
recording of your message (speak near your collar). At the end of the recording, loosen the
button.
- To listen and verify your message 1, select the mode 1 : release the button when the mode 1 is
reached (See diagram 6).
- Your collar plays message 1.
For your message 2, proceed in the same way by selecting mode 4 to record it and mode 2 to listen
to it.
- Replace the battery cover taking care to first insert the little pin at the bottom of the battery
cover (See diagram 3).
- Retighten moderately the 2 screws.
The chart below presents the different modes concerning the recording and listening of vocal
messages:
Number of sound beeps heard
when switching modes
1
2
3
4
Mode
1 Listening of vocal message 1
2 Listening of vocal message 2
3 Recording of vocal message 1
4 Recording of vocal message 2
Gb - 17
Operation