Listening To The Radio - Teac LP-R500 Mode D'emploi

FM MODE
1 Select FM or AM using the FM/AM button.
2 Select the station you want to listen to (auto selection).
Hold down the TUNING button (
display begins to change.
< When a station is tuned in, the tuning process will stop
automatically.
< Press the TUNING button (
14

Listening to the Radio

or ) until the frequency
or ) to stop the auto selection.
Selecting stations which cannot be tuned automatically
(manual selection)
When the .m or ,/ button is pressed momentarily,
the frequency changes by a fixed step.
Press the .m or ,/ button repeatedly until the
station you want to listen to is found.
FM MODE button
Pressing this button alternates between STEREO mode and
MONO mode.
STEREO
FM stereo broadcasts are received in stereo and the "STEREO"
indicator lights in the display.
< If the sound is distorted and the "STEREO" indicator blinks, the
signal is not strong enough for good stereo reception. In this
case, change to MONO mode.
MONO
To compensate for weak FM stereo reception, select this mode.
Reception will now be forced to monaural, reducing unwanted
noise.
If the reception is poor
AM broadcast
Turn around the AM antenna and/or the unit to find the best
position for AM stations.
FM broadcast
Extend and turn around the FM antenna so that you can receive
the stations clearly.
< If the reception was not improved, an outdoor antenna may be
required.