Range Measurement - Leica GEOVID HD-B Notice D'utilisation

RANGE MEASUREMENT

To measure the range to an object, you must aim
directly at it. To do this, proceed as follows:
1. Press the main / release button (7). The range
finder is activated.
• The reticule appears.
When you let go of the main / release button, the
reticule is lit for a further six seconds. If you hold the
button down, the reticule remains lit.
2. Aim at the object while the reticule is lit.
3. Press the main / release button (7).
a. The reticule disappears briefly during the
measurement.
b. The measured value is displayed.
As long as the reticule is still lit, a new measurement
98
can be started at any time by pressing the main /
release button again.
The display shows:
– the object distance is less than 10 meters/yards,
or
– the range is exceeded, or
– the object is not sufficiently reflective.
When the display disappears, the range meter is
automatically deactivated.
if
- - -
37