Würth 1952 006 505 Traduction Des Instructions De Service D'origine page 14

screw and the entire tool are in axis during the operation. During
the job, always use the tool from point X and not from the M16
screw.
If you use the tool from the M16 screw it will not
work as it should and could get damaged.
INSERTION:
• Fit silentblock onto screw and place it with head on washer
with bearing 1952 006 506 (ref. A); get screw onto other side
of support and position milled washer 1952 006 556 (ref.
F); screw nut M12, checking that everything is aligned before
screwing (fig. 11).
• Oil silentblock (and, before, seat) and use two 30 mm wrenches
to rotate nuts. Keep screwing until silentblock is fully inserted.
14
9
10
F H
11
C A
D
X G E
F C