Ventilation System - Nolan N87 Plus Sécurité Et Instructions D'utilisation

- Should the Nolan Emergency Release System (NERS) fail or be damaged, please
contact a Nolangroup authorized dealer.
- Use the Nolan Emergency Release System (NERS) for providing assistance only
if you have proven expertise and qualifications in the field. If in doubt, call the
appropriate emergency personnel.
WIND PROTECTOR
(Available as standard or accessory/spare part).
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
16 Wind Protector disassembly
To remove the wind protector, pull it towards the outside of the helmet at the three
fastening flaps (Fig.23).
Then check that the front press studs of side cheek pads are still properly engaged.
17 Wind Protector assembly
To fit the wind protector, gently pull the front part of the left cheek padding towards
the inside of the helmet, and then insert the left side flap of the wind protector in the
corresponding housing on the lining of the inner chin guard and push it downwards
until it hooks in place completely. Then repeat this process also for the centre flap
and the right flap (Fig.23).
Then check that the front press studs of side cheek pads are still properly engaged.

VENTILATION SYSTEM

The ventilation system consists of:
Chin guard air intake:
For the maximum effectiveness of the ventilation, adjust the air intake as per Figure
24A, with the air intake completely open or Fig.24B, with air intake completely closed.
Front air intakes (left and right):
nels the air coming from the front air intake by directing it in the top area of the rider's
head without any dispersion. See Fig.25 for opening and closing.
Rear extractor:
stale air, ensuring maximum comfort inside the helmet (Fig.26).
N-COM - NOLAN COMMUNICATION SYSTEM PRE-SETTING
(Available depending on the product version)
Your Nolan helmet is factory-preset to be equipped with the N-Com communication
system. During the communication system installation (see the specific instructions
contained in the N-Com kit), it will be necessary to remove the foam material fillers
located in the polystyrene cheek pads next to the N-Com earphones seats.
A series of supports are also provided as an accessory which MUST be used to fas-
ten the various N-Com keypads to the helmet's shell. Please contact an authorized
Nolan Dealer.
- The above-mentioned fillers should only be removed if the helmet is used with an
N-Com compatible system installed.
allows ventilation in the mouth and visor area.
is integrated into a rear spoiler and allows the removal of warm and
the innovative AIRBOOSTER TECHNOLOGY chan-
23