Nolan N87 Plus Sécurité Et Instructions D'utilisation page 19

5 VPS disassembly
5.1 To remove the sun screen from the helmet, open the visor completely and lower
the VPS by rotating the side slider completely upwards (Fig.7B).
5.2 Hold the left lateral part of the sun screen and pull it toward the outside of the
helmet (Fig.8).
5.3 Repeat the same operation on the right side of the helmet.
6 VPS assembly
6.1 To assemble the sun screen on the helmet, open the visor completely and push
the side slider completely upwards (Fig.7B).
6.2 Insert the sun screen left end into the left side guide until the grip pawl is hooked
in shell housing (Fig.8).
6.3 Repeat the same operation on the right side of the helmet.
WARNING
- Make sure the VPS operates correctly by moving the left side slider towards the
bottom (Fig.7A) and the top side of the helmet (Fig.7B) until you hear the clicks
meaning that it enters the relative positions. If necessary, repeat the above-men-
tioned steps.
- If the VPS opening/closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolan authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- a liner
- side cheek pads (right and left)
All components can be completely removed and washed.
The cheek pads are also characterised by removable inner expanding foam padding.
To remove the inner comfort padding, lift the VPS, open the visor completely and
remove the chin guard from the helmet (see instructions above).
7 CHEEK PADS DISASSEMBLY
7.1 Open the chin strap (see relevant instructions).
7.2 Gently pull the red strap in the front area of the left cheek pad to release the
safety lever placed on the back (Fig.9).
7.3 Grasp the front part of the left cheek pad and turn it upwards to unhook the front
hook and the upper snap fastener, placed on the back (Fig.10).
7.4 Pull the back of the left cheek pad towards the inside of the helmet to release the
rear snap fastener placed on the back (Fig.11).
7.5 Remove the rear flap of the comfort padding of the left cheek pad from the cavity
between the rear seal and the inner polystyrene shell; then completely remove
the cheek padding from the helmet (Fig.12).
7.6 Repeat the same process with the right cheek padding.
N.B.: Do not remove the polystyrene cheek pads from the helmet shell.
19