Nolan N87 Plus Sécurité Et Instructions D'utilisation page 21

12.2 Insert the chin strap into the cavity in the cheek padding and press near the
rear snap fastener placed on the back to hook it in the relevant housing in the
polystyrene cheek pad (Fig.11).
12.3 Press the left cheek pad against the polystyrene cheek pad and simultaneously
turn it inwards to fasten the front hook placed on the back (Fig.10).
12.4 Press near the upper snap fasten to hook it in the relevant housing in the poly-
styrene cheek pad.
12.5 Press the safety lever upwards near the fastening area of the red strap to turn it
towards the cheek padding until it reaches its closing position. (Fig.9).
12.6 Check whether the fasteners and the hook are correctly fastened by slightly
pulling the cheek pad towards the inside of the helmet and checking whether it
remains adherent to the polystyrene cheek pad.
12.7 Repeat the same process with the right cheek padding.
WARNING
If your helmet is equipped with the D-Ring retention system, pull it down as
-
indicated in the attached D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet without having completely and correctly reassembled its
inner comfort padding.
- Delicately hand-wash and use neutral soap and water at 30° max only.
- Rinse with cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the internal polystyrene components in any way.
- Clean the inner polystyrene components with a damp cloth only and allow it to
dry at room temperature away from direct sunlight.
- Never use tools or equipment of to carry out the steps described above.
LINER POSITIONING CONTROL (LPC)
13 Liner positioning control
The different anatomic shape of the rider's head at times requires to adapt the posi-
tion of the helmet to the head in question. Thanks to the LINER POSITIONING CON-
TROL (LPC), you can adjust the position of the liner which, considering the same size
of the helmet, allows to change the positioning of the helmet on the head with respect
to the standard one, adapting to various needs.
To adjust the liner deactivate the VPS, lift the chin guard of the helmet (see above
instructions), open the chin strap (see relevant instructions) and proceed as follows.
13.1 Overturn one side of the upper part of the padding and unhook the front circular
button for adjusting the liner below it from the underlying longitudinal plastic
support with 6 holes (Fig.17).
13.2 Move the circular button along the longitudinal plastic support and hang it up in
one of the two following holes (Fig.18).
13.3 Repeat the process of points 13.1 and 13.2 with the rear circular button located
below the padding (Fig.19).
N.B.: By pulling the two adjustment snaps of the liner, the helmet is gradually
positioned higher on the head.
13.4 After having correctly fastened the two adjustment snaps of the liner to the longi-
tudinal plastic support, fold and spread the upper padding in the correct position.
21