2
5
7
6
Fig. 4
• Then lower screw cover (2) onto
support tube disc.
Fig. 5
• Hold sunshade firmly upright, lift
screw cover (2) and insert the 5
anchorage screws (5), do not yet
tighten.
• Straighten sunshade and tighten
anchoring screws.
• If sunshade is not already perpen-
dicular: loosen anchoring screws
(5) slightly and adjust with plate
screws (6).
• Tighten anchoring screws again.
• Insert connecting bolts (1) under
the cover and lock if necessary
(7),
3.4 Installation with Positioning Hinge Option (for Ground Socket M8)
(particularly appropriate in the case of electrical installation)
3.4.1 Preparation (2 adults are required)
• For the connection of the pole to the positioning hinge, proceed as
described in Fig. 2.
• Unscrew lid from ground socket (1) (Fig. 6).
• Remove fixing stay (2) from pole base and push jacking ring (3) up
over crank opening (4). Pad against pole and secure with inserted
crank.
• Loosen safety screw (5), fold out hinge plate (6) and place on
ground socket (Fig. 7).
• Tighten hinge disc to ground socket using twisting mounts (7). Use
central threaded holes.
• In the case of sunshades with electrical installation, connect plug
(8). Stow loose cable in the ground socket.
1
2
3
2
Fig. 6
4
3
7
7
8
6
|EN
13
Fig. 7
5
7
8