Maintenance And Care; Disposal Information; Declaration Of Conformity - Flex ALC 3/360-G/R 10.8 Notice D'instruction D'origine

Maintenance and care

WARNING!
In order to maintain the product performance,
you should always follow these simple
directions below.
Cleaning
■ Keep the measuring tool clean at all times.
■ Do not immerse the measuring tool in
water or other fluids.
■ Always keep the product free of dust and
liquids as much as possible. Use only a
clean, soft cloth for cleaning. If necessary,
slightly moisten the cloth with pure alcohol
or a little water. Do not use any cleaning
agents or solvents. Do not Wash with water
directly.
■ Do not touch the lens with your fingers.
■ Regularly clean the surfaces at the exit
opening of the laser in particular, and pay
attention to any fluff or fibers.
Storage
■ Always store the product indoors. Always
handle or store the product with original
packaging parts.
■ Store and transport the measuring tool
only in the protective pouch or in the case.
Battery
■ While the product not been in use for
long time, do regular inspection on the
batteries. Take off the batteries or charge
and discharge the Li-ion battery to extend
the service life.
■ Charge the Li-ion battery or change the
batteries when the low battery capacity
warning occurs.
Repairs
■ Do not attempt to repair or disassemble the
product. Any repair or disassemble required
on this product should be performed only
by authorized service personnel, otherwise
serious injury may occur.
Spare parts and accessories
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
22

Disposal information

WARNING!
Render redundant tools unusable:
mains operated tool by removing the
power cord,
battery operated tool by removing the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EC on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of waste
disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recyding according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal options!

-Declaration of Conformity

We declare under our sole responsibility
that the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 60745 in accordance with the regulations
of the directives 2014/30/EC, 2006/42/EC,
2011/65/EC.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Head
ALC 3/360-G/R 10.8
Klaus Peter Weinper
Head of Quality
Department (QD)