Speed Settings; Optional Accessories - Hilti GPB 6X-A22 Mode D'emploi

6 Types of work
6.1 Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
➥ The motor runs.
3. Lock the on/off switch.
6.2 Setting the speed
▶ Use the adjusting knob to set the speed.
6.2.1

Speed settings

Stage 1
Stage 2
Stage 3
Stage 4
Stage 5
Stage 6
6.3 Grinding 5
CAUTION
Risk of injury! Grinding makes the workpiece hot.
▶ Do not attempt to touch the workpiece immediately after grinding and always wear suitable protective
gloves to prevent burns. Keep everyone clear of your work zone.
1. Lift the satin finisher clear of the work surface.
2. Switch the tool on. → page 19
➥ The power tool then runs in sustained operating mode.
3. Set the speed. → page 19
4. Bring the satin finisher with the tool into contact with the work surface and keep it moving with a steady
back-and-forth action.
5. Apply moderate pressure and do not press the abrasive belt into the material.
6. For a decorative surface finish, move the satin finisher only with a steady back-and-forth, linear action.
Avoid movements at angles to the work.
6.4 Using the fence
The fence ensures precision in-line action for working on profiles.
1. Release the locking screw on the fence.
2. Adjust the fence.
3. Tighten the locking screw.
6.5 Switching off
▶ Press the rear section of the on/off switch.
➥ The on/off switch jumps into the off position and the motor stops.
7

Optional accessories

7.1 Installing the extractor hood 7,
1. Remove the securing screw for the guard.
2. Turn the locking ring for guard attachment to open it.
3. Pull the guard up toward the grip and off the gear head.
4. From above, slip the extractor hood into the holder.
*2241316*
6
8
2241316
1,220 /min
1,360 /min
1,560 /min
1,840 /min
2,240 /min
2,750 /min
English 19