Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Attach the card reader to the inside of the card reader bezel
per instructions from the card reader manufacturer.
8.
Install the assembled card reader-bezel assembly into
the control panel and secure with the 2 screws in literature
package.
A. Card reader bezel and card reader
9.
Plug the wiring harness into the card reader and the card
reader port on the control board at AA3.
10. Reinstall the console panel assembly and outer control
panel by reversing steps 6 and 4, and for washers, 3.
Dryer shown.
11. Reinsert detergent dispenser assembly (washer only).
1.
Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2.
Check that you have all of your tools.
A
3.
Dispose of/recycle all packaging materials.
4.
Washers & Gas Dryer
Plug into a grounded 3 prong outlet.
5.
Electric Dryers
In the U.S.A.:
For power supply cord installations, plug into a grounded
(earthed) outlet. For direct wire installations, turn on power.
In Canada:
Plug into a grounded 4 prong outlet. Turn on power.
If you need assistance:
Contact the distributor where the washer was purchased or visit
www.whirlpoolcommerciallaundry.com.
When you call, you will need the washer model number and
serial number. Both numbers can be found on the serial-rating
plate located on your washer.
Complete Installation
Assistance or Service
3
Publicité
Table des Matières
