Installation Instructions; Tools And Parts; Installing The Card Reader - Maytag MDG25PRAWW Instructions D'installation

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Security T-20 TORX
®†
■
Parts supplied
Check that all parts were included.
Bezel
■
Wiring harness
■

Installing the Card Reader

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug washer or dryer or disconnect power.
2. It is recommended to cover the top of the washer or dryer
to avoid scratching the top or the console parts.
3.
Pull out and remove dispenser from washer.
† ® TORX is a registered trademark of Textron Innovations, Inc.
2

INSTALLATION INSTRUCTIONS

driver Phillips screwdriver
■
Card reader
■
Phillips-head screws (2)
■
4. Remove the outer console panel:
Washer:
Remove the 6 TORX
®
outer console panel to the control panel assembly.
Dryer:
Remove the 8 Torx T20 security screws attaching the outer
®
console panel to the control panel assembly.
5. Remove the card reader slot cover. Discard card reader
slot cover. Dryer shown.
A. Card reader slot cover
6. Remove the control panel assembly. Dryer shown.
T20 security screws attaching the
A