Skytec Polaris DMX LED Flower 162 Mode D'emploi page 6

DMX Terminator
At the last fixture in the chain, the DMX output has to be connected with a DMX terminator. This prevents
electrical noise from disturbing and corrupting the DMX control signals. The DMX terminator is simply an
XLR connector with a 120 Ohm resistor connected across pins 2 and 3, which is then plugged into the
output socket on the last projector in the chain. The connections are illustrated below.
PIN 3
PIN 2
Specification:
Power: .................................................................................................230V / 50Hz ~
Power consumption: .......................................................................................... 20W
LEDs: ................................................................................60 Red, 36 Green, 66 Blue
DMX Channels: .........................................................................................................6
Weight:...................................................................................................................5kg
Size (LxWxH):.............................................................................. 335 x 305 x 285mm
Maximum ambient Temperature Ta: ....................................................................45°C
Fuse:..................................................................................................................... F1A
•
Specifications and design are subject to change without prior notice.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any
changes to the unit. This would also invalid your warranty. The warranty is not applicable in case of
accidents or damages caused by inappropriate use or disrespect of the warnings contained in this
manual. SkyTronic cannot be held responsible for personal injuries caused by a disrespect of the safety
recommendations and warnings. This is also applicable to all damages in whatever form.
6