Slave Mode; Dmx Mode - Skytec Polaris DMX LED Flower 162 Mode D'emploi

Automatic / Sound active mode:
Set DIP switch 10 to ON position DIP switch 9 to OFF. Program and sound mode can be selected via DIP
.
switches 1 to 8
Function
8
7
6
5
4
3
2
1

Slave mode:

Set DIP switch 10 & 9 to ON. The master unit will control now all the slave units. Select on the master
device the program mode Automatic / Sound active mode this device then works as master device and
controls all other slave devices which are to be connected to the master device via a 2 core screened
cable. Connect the out XLR connector with the IN connector of the next device.

DMX mode:

Set DIP switch 10 to OFF position and control the DMX receiving address with dip switches 1-9 and you're
all set-up to start the DMX receiving mode.
(Note: 1 = On, 0 = Off)
DMX DIP Switches
Address 9 8 7 6 5 4 3 2 1
01 0 0 0 0 0 0 0 0 1
02 0 0 0 0 0 0 0 1 0
03 0 0 0 0 0 0 0 1 1
04 0 0 0 0 0 1 1 0 0
... .. .. .. .. .. .. .. .. ..
509 1 1 1 1 1 1 1 0 1
Instruction
Automatic mode
Sound mode
All shining
Twinkling mode 1
Twinkling mode 2
Twinkling mode 3
Auto speed 2(quick)
Auto speed 1(slow)
4