Makita PV7001C Manuel D'instruction page 6

Hold the spindle with the wrench so that it cannot revolve.
Then screw the pad onto the spindle all the way. (The
pad can be used to install the optional sponge pad.)
To remove the pad, follow the installation procedure in
reverse.
Installing or removing sponge pad
(optional accessory)
1
To install the sponge pad, first remove all dirt or foreign
matter from the pad. Install the sponge pad to the pad.
To remove the pad, pull it off from the pad slowly.
Installing or removing the wool bonnet
(optional accessory)
1
3
2
Mount the rubber pad onto the spindle. Screw the lock
nut onto the spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
Fit the wool bonnet completely over the rubber pad and
pull the string tight. Tie a bow knot and tuck the knot and
any loose strings between the wool bonnet and the rub-
ber pad.
003454
1. Sponge pad
2. Pad
2
003468
1. Wool bonnet
2. Lock nut
3. Rubber pad
003469
1. Lock nut wrench
2. Wrench
2
To remove the wool bonnet, follow the installation proce-
dure in reverse.
Installing or removing abrasive disc
(optional accessory)
1
2
3
NOTE:
• Use sander accessories specified in this manual.
These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the abrasive
disc on the rubber pad and screw the lock nut onto the
spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
To remove the disc, follow the installation procedure in
reverse.
6
003470
003414
1. Lock nut
2. Abrasive disc
3. Rubber pad
4. Spindle
4
003418
1. Lock nut wrench
2. Wrench
2