Makita PV7001C Manuel D'instruction page 5

Speed adjusting dial
2
The tool speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the
direction of number 5. And lower speed is obtained when
it is turned in the direction of number 1.
Refer to the table for the relationship between the num-
ber settings on the dial and the approximate tool speed.
Number RPM (/min)
1
|
2
|
3
|
4
|
5
CAUTION:
• If the tool is operated continuously at low speeds for
a long time, the motor will get overloaded, resulting
in tool malfunction.
• The speed adjusting dial can be turned only as far
as 5 and back to 1. Do not force it past 5 or 1, or the
speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
• Electronic constant speed control
Possible to get fine finish, because the rotating
speed is kept constantly even under the loaded
condition.
• Soft start feature
Soft start because of suppressed starting shock.
High-Low speed setting button
1
003408
1. Speed adjust-
ing dial
1
003443
600
|
800
|
1,300
|
1,800
|
2,000
003444
1. High-Low speed
setting button
The tool speed can be changed instantly while the tool is
running. Depress the "I" position for lowest speed and
depress "II" position for a given number setting.
The tool speed cannot be changed when the button is in
"I" position, even if you turn the speed adjusting dial.
When you turn the speed adjusting dial, always be sure
that the button is depressed in "II" position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing side grip (auxiliary handle) & cover
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Install the cover, then screw the side grip on the tool
securely. The side grip and the cover can be installed on
either side of the tool.
1
2
1
2
Installing or removing backing pad
1
5
003412
1. Cover
2. Side grip
003413
1. Cover
2. Side grip
003453
1. Backing pad
2. Spindle
2 3. Wrench
3