Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with
product (gained from repeated use)
replace strict adherence to polisher
safety rules. If you use this tool unsafely
or incorrectly, you can suffer serious per-
sonal injury.
1.
Accessories must be rated for at least the speed
recommended on the tool warning label. Wheels
and other accessories running over rated speed can
fly apart and cause injury. Maximum operating
speed of accessories should be higher than the
highest no load speed marked on the tool's name-
plate.
2.
Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord. Con-
tact with a "live" wire will make exposed metal parts
of the tool "live" and shock the operator.
3.
Check the backing pad carefully for cracks, dam-
age or deformity before operation. Replace
cracked, damaged or deformed pad immediately.
4.
NEVER use tool with wood cutting blades or
other sawblades. Such blades when used on a
polisher frequently kick and cause loss of con-
trol leading to personal injury.
5.
Hold the tool firmly.
6.
Keep hands away from rotating parts.
7.
Make sure the abrasive disc or wool bonnet is
not contacting the workpiece before the switch
is turned on.
8.
When sanding metal surfaces, watch out for fly-
ing sparks. Hold the tool so that sparks fly away
from you and other persons or flammable mate-
rials.
9.
Do not leave the tool running. Operate the tool
only when hand-held.
10. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
11. Check that the workpiece is properly supported.
12. Pay attention that the wheel continues to rotate
after the tool is switched off.
13. This tool has not been waterproofed, so do not
use water on the workpiece surface.
14. Ventilate your work area adequately when you
perform sanding operations.
15. Use of this tool to sand some products, paints
and wood could expose user to dust containing
hazardous substances. Use appropriate respira-
tory protection.
SAVE THESE INSTRUCTIONS
USB047-4
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V ........................... volts
A ........................... amperes
Hz ......................... hertz
.................. alternating current
...................... no load speed
.../min ................... revolutions or reciprocation per
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
1
2
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
•
Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
4
minute
003407
1. Switch trigger
2. Lock button
USD101-2
Publicité
Table des Matières
