Display On/Off - Skytec Helios DMX LED 4 Flower 192 Mode D'emploi

5 PIN SOCKET
Pin 1: GND (Screen)
Pin 2: Signal (data -)
Pin 3: Signal (data +)
Pin 4: N/C
Pin 5: N/C
DMX Terminator
At the last fixture in the chain, the DMX output has to be connected with a DMX terminator. This prevents
electrical noise from disturbing and corrupting the DMX control signals. The DMX terminator is simply an XLR
connector with a 120 Ohm resistor connected across pins 2 and 3, which is then plugged into the output socket
on the last projector in the chain. The connections are illustrated below.
PIN 3
PIN 2
Set Up:

Display on/off

With this function you can shut off the LED display (13)
3 PIN PLUG
5 PIN PLUG
Pin 1: GND (Screen) Pin 1: GND (Screen)
Pin 2: Signal (data -) Pin 2: Signal (data -)
Pin 3: Signal (data +) Pin 3: Signal (data +)
Pin 4: N/C
Pin 5: N/C
3 PIN SOCKET
Pin 1: GND (Screen)
Pin 2: Signal (data -)
Pin 3: Signal (data +)
5