Fitting The Battery - Num'axes Canibeep PRO Guide D'utilisation

Adjustment screw
for movement detection
sensitivity
Polarity "-"
of the battery
3V lithium CR123A
battery

Fitting the battery


– Unscrew the 4 screws of the top of CANIBEEP PRO collar using a Philips screwdriver.
– Insert the battery (3V lithium CR123A) paying attention to follow polarity indicated on the
battery housing (see Diagram 2).
– A beep sound (low pitch) is emitted and the red indicator LED flashes, indicating the battery
has been properly inserted.
– Put the top cover back in place in the right way. Check that the led window is located right
above the red indicator LED inside the collar (see Diagram 1). Ensure that the rubber seal is
in its groove, and check that both rubber seal and groove are clean in order to avoid any water
tightness problem.
– Firmly screw up the 4 screws in order to maintain your product's water tightness.
You can now turn your CANIBEEP PRO collar On.
GB - 18
Diagram 2
Sound volume setting screw
Battery type and polarity
indicator
Red indicator
LED
Polarity "+"
of the battery