Cautions For Use - Num'axes Canibeep PRO Guide D'utilisation

If you use both CANIBEEP PRO collar and CANICOM training collar at the same time, we advise
you to attach the CANICOM receiver on the same strap but at the opposite side of the CANIBEEP
PRO receiver in order to prevent the two receivers from banging together (training receiver
under the dog's neck).

Cautions for use


– We advise you to use the CANIBEEP PRO collar on dogs over 6 months old.
– Before using the collar, have your dog checked by a veterinarian to ensure it is fit to wear a
beeper collar.
– To prevent damaging your CANIBEEP PRO, we advise against your dog wearing a metal identity
tag, metal collar, collar bell or any other collar around his neck when it is wearing its beeper
collar. Yet, if you wish to use along with your CANIBEEP PRO another tool (training collar, collar
bell, metal identity tag...) we advise you to attach them on the same strap but at the opposite
side of the CANIBEEP PRO receiver in order to prevent them from banging together.
– Give your dog time to get used to the sounds of the CANIBEEP PRO. The volume of the sound
might scare the dog at the beginning: to help him get used to CANIBEEP PRO, lower the sound
volume thanks to the volume adjustment screw (§ Adjusting sound volume).
In this way you will reduce the volume and with time your dog will familiarize himself with this
new product from the NUM'AXES range.
– If your dog shows any behavioural problems, we suggest you ask your veterinarian for advice.
– Avoid using CANIBEEP PRO indoors: the volume (approx. 94 dB A) could irreversibly damage
your ear-drums.
– It is easier to start the collar and adjust sound or mode before you put it on your dog.
– CANIBEEP PRO is watertight, so your dog can cross any watercourse without damaging it.
However, if CANIBEEP PRO remains under water for a long period of time, the cavity of the
sound diffuser may become filled with water, and the emission power will be reduced.
To restore the unit performance, shake your CANIBEEP PRO, holding the diffuser downwards,
to let all the water out.
– Before using the collar, check that the seal is clean and well positioned in its groove, and also
check that the 4 screws of the top of the unit are properly tightened in order to ensure the
water tightness of your product.
– In order to maintain water tightness, we recommend the replacement of the seal in the collar
every year.
GB - 26