A)
GAS CONNECTION
NL
Cat:
The gases used for the operation of
cooking appliances may be grouped by
their characteristics into two types:
•
G25.3 Natural gas
•
G20 Natural gas
•
G30 / G31 Butane/Propane
The fitting (fig. 8.2) is made up of:
A - Gas train terminal fitting (rh or lh)
B - Gasket
C - Conical connector
Use rigid or flexible connection pipes
which comply with applicable regulations.
If compression fittings are used, tighten
firmly using two spanners (fig. 8.4).
In particular, make sure that:
•
the flexible hose does not come into
contact with any parts of the cooker
with surface temperatures in excess
of 70˚C;
•
the flexible hose does not exceed 75
cm in length and does not come into
contact with sharp edges or corners;
A
B
C
1/2" gaz conique
II
2EK3B/P
NL
Fig. 8.2
•
the hose is not under tension or
twisted and is not kinked or too tightly
bent;
•
the connection with rigid metal pipes
should not cause stresses to the gas
ramp.
•
we advise replacing the gasket on
the slightest sign of deformation or
imperfection.
•
the hose can easily be inspected
along its entire length to check its
condition; hoses should replaced after
a maximum of three years.
•
the cylinder cock or the supply cock
immediately ahead of the appliance
is closed whenever the cooker is not
in use.
This appliance was configured for
the appliance category K (I
is suitable for the use of G and G+
distribution gases according to
the specifications as included in
the NTA 8837:2012 Annex D with a
Wobbe index of 43.46 – 45.3 MJ/m
(dry, 0 °C, upper value) or 41.23 –
42.98 (dry, 15 °C, upper value).
This
appliance
be converted and/or again be
calibrated
for
category E (I
).
2E
This therefore implies that the
appliance: "is suitable for G+ gas
and H gas or is demonstrably
suitable for G+ gas and can
demonstrably be made suitable
for H gas" within the meaning of
the "Dutch Decree of 10 May 2016
regarding amendment of the Dutch
Gas Appliances Decree...".
) and
2K
3
can
moreover
the
appliance
227