Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONNECTION OF THE POWER SUPPLY CABLE
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
•
Unhook the terminal board cover by inserting a screwdriver into the two hooks "A"
(fig. 9.1).
•
Open the cable gland by unscrewing screw "F" (fig. 9.2), unscrew the terminal
screws.
•
Insert the feeder cable of the suitable section (as described in the next chapter)
into the cable gland.
•
Connect the phase and earth cables to the terminal block according to the diagram
in figure 9.3.
•
Pull the feeder cable and block it with cable gland.
•
Close the terminal block cover (check the two hooks "A" are correctly hooked).
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws
fixing the cover plate behind the terminal block.
N.B. The earth conductor must be left about 3 cm longer than the others.
FEEDER CABLE SECTION Type "H05RR-F"
220-240 V ac
(*) – Connection possible with plug and outlet
Fig. 9.1
238
3 x 1,5 mm
2
(*)
A
F
Fig. 9.2
230 V
220-240 ac
L
N
PE
Fig. 9.3
Publicité
Table des Matières
