Auto Mode; Dmx Mode; Dmx Protocol - Evolite MOVING WASH 36x8Z Mode D'emploi

.Press the MENU until it shows RTOF
.Use the UP/DOWN buttons show RTON, press ENTER to confirm.
To set the LED readout to 180°,rotating
.Press the MENU until it shows RDOF.
.Use the UP/DOWN buttons show RDON, press ENTER to confirm.
Resume reverse Windows default
.Press the MENU until it shows DFON.
.press ENTER to confirm。
o Auto Mode
Setup single-desk light`s autocephaly moving mode(auto-running)
.Press the MENU until it shows AU01
.Use the UP/DOWN buttons to set to AU01 or AU02 ,Press ENTER to confirm.
Setup single-desk light`s autocephaly moving mode(sound control)
.Press the MENU button until it shows SNOF .
.Use the UP/DOWN buttons to set to SNOF,press ENTER to confirm.
o DMX Mode
DMX mode is selected in the main menu (make sure fixture is not in Auto Mode).
You can control the projectors individually via your DMX-controller
Just select the fixture address, knowing that this address will be the start address. ( 1
The MOVING BEAM 5R provides 2 DMX modes:
1- 8 channels DMX mode
2- 16 channels DMX mode.
These 2 channels are selected in the main menu by the OPTION function.
Note. If 2 MOVING BEAM are addressed with same DMX value, they will move exactly the same way.
o DMX-protocol
Channel
1
2
3
4
5
MOVING WASH 36x8Z Manual Ver. 1.02
Value
Dimmer
0-255 0~100% dimmer
Red
0-255 0-100% Red
Green
0-255 0-100% Green
Blue
0-255 0-100% Blue
White
0-255 0-100% White
st
DMX channel).
Function
Page 16