Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
o Master/ Slave Mode
.This mode will allow you to link up 32 units together without a controller.
.Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of
the units.Proper performance it may be necessary to use a terminator at the last fixture. For more
information about terminators..
Set the desired master-mode- "Automatic program mode" or"sound controlled mode", for the
master-device, send the DMX address 1 for all slave-devices. Please refer to the instruction under
control board.
Maintenance & service
o Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause
greater accumulation of dirt on the fixture's optics.
Clean with soft cloth using normal glass cleaning fluid.
Always dry the parts carefully.
Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days
o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy
troubleshooting:
The fixture does not work, no light
o
Check the connection of power and main fuse.
MOVING WASH 36x8Z Manual Ver. 1.02
60-69
ID 6
70-79
ID 7
80-89
ID 8
90-99
ID 9
100-109
ID 10
110-119
ID 11
120-129
ID 12
130-139
ID 13
140-149
ID 14
150-159
ID 15
160-169
ID 16
170-179
ID 17
180-189
ID 18
190-199
ID 19
200-209
ID 20
210-219
ID 21
220-229
ID 22
230-239
ID 23
240-249
ID 24
250-255
ID 25
Page 18
Publicité
Chapitres
Table des Matières
