Auto Mode - Evolite Moving Beam 7R Mode D'emploi

Pan / Tilt
UI SET
Information Lampe Hours
Temperature
Fan parameter
Manual Reset
Control
Channel
Advanced Calibration
(Access
Clear lamp time
Code 088)
o Auto Mode
Press the MENU key then ENTER, then use the DOWN key to reach the AUTO RUN menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
Sound Mode :
Press the MENU key then ENTER, then use the DOWN key to reach the Music Control menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
Moving Beam 7R User's Manual Ver. 1.00
Reverse Pan (On/Off)
Reverse Tilt (On/Off)
Select Pan 630°/540°/360°
Select Tilt 270°/180°/90°
Mic sensitivity 0~99%
OFF Signal Mode (On/Off)
Half Color Wheel
Xxxx(Hours)
Xxx°C/°F
Current = xxxxmA, Voltage = xxxxmV
Total Reset
Pan/Tilt Reset
Color Reset
Gobo Reset
The Others Reset
PAN=XXX......
PAN=XXX......
Yes/No
Reverse Pan
Reverse Tilt
Pan max angle
Tilt max angle
Sound mode mic
sensitivity
Keep last DMX values
Half colors
Lamp use time
Current temperature
Fan parameters
Reset total
Pan/Tilt Reset
Coleur Reset
Gobo Reset
Other Reset
Manual mode
Calibration (factory only)
Reset lamp time
Page
23