M ENU M AP
DMX Address (DMX address 001-512)
Mode (DMX mode 11/15 ch, Auto mode1~8,sound mode)
TEST mode (X,Y,Red,Green,Blue,White)
Language (Chinese,English,)
Setting (ID code0-25,X reverse,Y reverse,Fade delay,dmx singal,endcode,temperature
Protection,Temperature,fans seepd,screen protection,screen reverse, factory reset, rest motor,
System info (running time, total running time, software version, run mode, address, temperature
Note:output default setting address code is A001, pan is positive circumrotate、tilt is positive
circumrotate、LED positively reveal.
To set the pan to reverse
.Press the MENU until it shows RPOF.
.Use the UP/DOWN buttons show RPON, press ENTER to confirm.
To set the tilt to reverse
.Press the MENU until it shows RTOF
.Use the UP/DOWN buttons show RTON, press ENTER to confirm.
To set the LED readout to 180°,rotating
.Press the MENU until it shows RDOF.
.Use the UP/DOWN buttons show RDON, press ENTER to confirm.
Resume reverse Windows default
.Press the MENU until it shows DFON.
.press ENTER to confirm。
o Mode Automatique
Setup single-desk light`s autocephaly moving mode(auto-running)
.Press the MENU until it shows AU01
.Use the UP/DOWN buttons to set to AU01 or AU02 ,Press ENTER to confirm.
Setup single-desk light`s autocephaly moving mode(sound control)
.Press the MENU button until it shows SNOF .
.Use the UP/DOWN buttons to set to SNOF,press ENTER to confirm.
o Mode DMX
Chaque appareil peut-être contrôlé individuellement grâce à un contrôleur DMX-512 standard.
Il faut « adresser » chaque appareil grâce au menu « Adresse DMX ». L'adresse renseignée est alors
l'adresse de base, adresse à partir de laquelle l'appareil va répondre.
Selon le mode de contrôle DMX sélectionné (8 canaux ou 16 canaux) , Le contrôleur DMX utilisé aura
besoin de 8 ou 16 canaux DMX pour contrôler la BEAM 5R.
Si deux BEAM 5R sont adressées à la même adresse DMX ; elles se comporteront alors de manière
identique, répondants aux mêmes canaux DMX.
MOVING WASH 36x8Z Manual Ver. 1.02
Page 7