Auto Mode; Dmx Mode - Evolite MOVING WASH 3x15C Mode D'emploi

To set the pan to reverse
.Press the MENU until it shows RPOF.
.Use the UP/DOWN buttons show RPON, press ENTER to confirm.
To set the tilt to reverse
.Press the MENU until it shows RTOF
.Use the UP/DOWN buttons show RTON, press ENTER to confirm.
To set the LED readout to 180°,rotating
.Press the MENU until it shows RDOF.
.Use the UP/DOWN buttons show RDON, press ENTER to confirm.
Resume reverse Windows default
.Press the MENU until it shows DFON.
.press ENTER to confirm。
o Auto Mode
Setup single-desk light`s autocephaly moving mode(auto-running)
.Press the MENU until it shows AU01
.Use the UP/DOWN buttons to set to AU01 or AU02 ,Press ENTER to confirm.
Setup single-desk light`s autocephaly moving mode(sound control)
.Press the MENU button until it shows SNOF .
.Use the UP/DOWN buttons to set to SNOF,press ENTER to confirm.
o DMX Mode
DMX mode is selected in the main menu.
You can control the projectors individually via your DMX-controller
Just select the fixture address, knowing that this address will be the start address. ( 1
Note. If 2 MOVING WASH are addressed with same DMX value, they will move exactly the same way.
MOVING WASH 3x15C Manual Ver. 1.02
st
DMX channel).
Page 14