SIKA SolarTemp Notice D'utilisation page 12

Savety instructions
Qualified personnel:
The personnel who are charged for the installation, operation and maintenance of the
SolarTemp must hold a relevant qualification. This can be based on training or relevant
tuition.
The personnel must be aware of this operating manual and have access to it at all times.
General safety instructions:
In all work, the existing national regulations for accident prevention and safety in the
workplace must be complied with. Any internal regulations of the operator must also be
complied with, even if these are not mentioned in this manual.
The measuring accuracy can be significantly influenced by the installation conditions, e.g.
by the installation depth and the heat conduction via the material at the screw-in position.
When measuring high media temperatures it is possible that the ambient temperature at
the thermometer housing will exceed the permissible maximum value (+60 °C). This may
damage the measuring instrument. We recommend the use of our SolarTemp with re-
mote cable when measuring media temperatures greater than 200 °C.
Always observe the specified degree of protection for the instrument.
Never open the display head, otherwise the degree of protection (IP65) cannot be guar-
anteed.
Never remove the protective tube of the temperature sensor while the system is operat-
ing!
Never touch the temperature sensor or connected components if the medium being
measured is subject to high temperatures.
It is recommended, if possible, to always install display heads at eye level (especially for
the remote thermometer).
Special safety instructions:
Attention:
If the thermometer is to be used in applications with high pressures and / or high tem-
peratures, high medium flow rates or corrosive and abrasive media, the thermometer
immersion tube has to be additionally protected by a protective tube in accordance with
DIN 43772.
Applies to the explosive atmosphere version:
The transmitter output of the thermometer should only be operated within a certified intrinsi-
cally safe circuit.
The connector can be disconnected in explosive atmospheres due to the certified intrinsically
safe circuit. This applies to the connector of the measuring sensor and the connector of the
transmitter output.
Further warnings that are specifically relevant to individual operating procedures or activities
can be found at the beginning of the relevant sections of this operating manual.
- 12 - © SiKA • Ba_SolTemp_en.doc 01/2011
SolarTemp