Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
TROUBLESHOOTING
NOTE: This pump has no serviceable parts inside case. Opening
case will ruin pump. If obstructions or blockages of impeller
cannot be cleaned out from the outside (for instance, by washing
out with a garden hose), replace pump.
Hazardous voltage; can shock, burn, or kill.
Unplug pump before attempting to clean pump.
TROUBLESHOOTING
SYMPTOM
POSSIBLE CAUSE(S)
Pump won't
1. Blown fuse.
start or run
2. Low line voltage
3. Defective motor.
4. Defective float switch
5. Impeller
6. Float obstructed
Pump starts and
1. Backflow of water from piping
stops too often
2. Faulty float switch
Pump will not
1. Defective float switch
shut off
2. Restricted discharge (obstacle in
piping
3. Float obstructed
Pump operates
1. Low line voltage
but delivers little
or no water
2. Something caught in impeller
3. worn or defective parts or
plugged impeller
4. Airlock (check valve installed
without vent hole)
For parts or assistance, call Flotec Customer Service at
CORRECTIVE ACTION
1. If blown, replace with fuse of proper size
2. If voltage under recommended minimum, check
size of wiring from main switch on property. If OK,
contact power company or hydro authority
3. Replace pump
4. Replace switch
5. If impeller won't turn, locate source of binding and clean out
hose or remove
6. Remove obstruction
1. Install or replace check valve
2. Replace pump
1. Replace switch
2. Remove pump and clean pump and piping
3. Remove obstruction
1. If voltage under recommended minimum, check size of wiring
from main switch on property. If OK, contact power company or
or hydro authority
2. Clean out impeller or replace pump
3. Clean out impeller if plugged; otherwise replace pump
4. If voltage under recommended minimum, check size of wiring
from main switch on property. If OK, contact power company or
or hydro authority
1-800-365-6832
4
Publicité
Table des Matières
