Connecting The Camera To A Local Network; Assigning The Ip Address Using The Setup Program - Sony SNC-RZ30N Manuel D'installation

Connecting the Camera to a
Local Network
SNC-RZ30N/RZ30P (rear)
18 16 14 12 10 8 6 4 2
17 15 13 11 9 7 5 3 1
!
DC IN 12V
DC IN
12 V
Ethernet cable
(straight, not
supplied)
Hub
Network
1
Using a commercially available
Ethernet cable, connect the
(Ethernet) port to a hub in the
network.
Use a UTP Category 5 straight cable for
the connection.
2
Connect the power cord to the
AC power adaptor (both
supplied), and connect the DC
IN 12 V connector of the camera
to an AC outlet.
AC power adaptor
(supplied)
Power cord
(supplied)
to an AC
outlet
10BASE-T/
100BASE-TX
Assigning the IP Address
Using the Setup Program
1
Insert the supplied CD-ROM
disc into your CD-ROM drive.
2
Double-click the Setup folder in
the CD-ROM drive.
3
Double-click Setup.exe.
4
Install the IP Setup Program to
your computer following the
wizard displayed.
If the Software License Agreement is
displayed, read it carefully and accept
the agreement to continue the
installation.
5
Start the IP Setup Program.
The program detects the SNC-RZ30
cameras connected on the local network
and lists them on the Network tab
window.
Assigning the IP Address to the Camera
13
GB