Num'axes Canicom Spray Guide D'utilisation page 21

Activate/deactivate the
receiver collar with the
remote control
• Coding of the remote control with the receiver collar
Each remote control has its own individual radio operator code.
The coding of the remote control with the receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding procedure, make sure no other people are
using their Canicom Spray or other products from the NUM'AXES range close by. Your
receiver collar could accidentally record the code of their remote control. If that
occurs, re-code the remote control with the receiver collar.
CODING PROCEDURE
WARNING: if you have two collars, you have to code them one at a time.
1 - Activate the remote control: press for 1 second the red On/Off button located on the side of
the remote control.
2 - Select the collar you want to code by pressing briefly the 0 button of the remote control (the
number 1 or 2 appears on the LCD screen).
3 - Receiver collar in position "deactivated" (indicator light off): move the remote
control towards the collar so that the
symbol located on the receiver collar, hold for 6 seconds. The indicator on the
with the
collar lights in fixed green then flashes in red.
4 - Move the remote control away from the receiver collar.
5 - Press the "beep sound" button of the remote control. The collar emits a beep sound; it is then
synchronized with your remote control.
If you have a second collar, renew the same procedure.
• Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a
new Canicom Spray remote control (ref. Coding procedure).
Gb - 21
Diagram 6
symbol of the remote control comes into contact