Dmx-512 Connection / Connection Between Fixtures; Addressing - EuroLite TS-7B Mode D'emploi

DMX-512 connection / connection between fixtures

Projector 1
Starting address 1
Typ/Type/Type/Tipo: EUROLITE TS-7B
Spannungsversorgung/Power supply/Aliment.: 230 V AC, 50 Hz ~
Ges. anschl. wert/Power cons./Puiss. de rendement/Cons.: 300 W
Sicherung/Fuse/Fusible/Fusible: F 3 A, 250 V
Lampe/Lamp/Lampe/Lámpara: ELC 24 V7250 W
Vor Gebrauch Anleitung lesen. Lire le mode d'emploi avant l'utilisation.
Lea el manual del usuario antes de la puesta en marcha.
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Addressing

Each projector occupies 6 channels. To ensure that the control signals are properly directed to each
projector, the projector requires adressing. This is to be done for every single projector by changing the DIP
switches as set out in this table.
Projector 2
Starting address 7
Typ/Type/Type/Tipo: EUROLITE TS-7B
Spannungsversorgung/Power supply/Aliment.: 230 V AC, 50 Hz ~
Ges. anschl. wert/Power cons./Puiss. de rendement/Cons.: 300 W
Sicherung/Fuse/Fusible/Fusible: F 3 A, 250 V
Lampe/Lamp/Lampe/Lámpara: ELC 24 V7250 W
Vor Gebrauch Anleitung lesen. Lire le mode d'emploi avant l'utilisation.
Lea el manual del usuario antes de la puesta en marcha.
DMX-512 Controller
the fixtures will not work at all, or will not work properly.
24/54
Projector 3
Starting address 13
Typ/Type/Type/Tipo: EUROLITE TS-7B
Spannungsversorgung/Power supply/Aliment.: 230 V AC, 50 Hz ~
Ges. anschl. wert/Power cons./Puiss. de rendement/Cons.: 300 W
Sicherung/Fuse/Fusible/Fusible: F 3 A, 250 V
Lampe/Lamp/Lampe/Lámpara: ELC 24 V7250 W
Vor Gebrauch Anleitung lesen. Lire le mode d'emploi avant l'utilisation.
Lea el manual del usuario antes de la puesta en marcha.
Ω
resistor
00026556.DOC, Version1.3
120 Ohms