SOLIS BREEZE 360 Mode D'emploi page 36

7. Fasten the rear protection grid using the rear nut (4). To do that, turn the rear
nut clock wisely towards "Tighten". (Fig. 5)
8. Now, push the rotor blade onto the motor shaft as well. The 2 pins on the motor
shaft have to glide into the two grooves in the rotor blade base (fig. 6). Fasten
the rotor blade with the rotor blade nut (2) by turning it counter clock wisely
towards "Tighten". The rotor blade should be able to turn freely afterwards.
(Fig. 7)
9. The frame ring connects the rear protection grid with the front protection grid.
First, remove the screw on the locking clip with a screwdriver and open the clip.
Place the frame ring on the rear protection grid (fig. 8), the guidance clip in
the frame ring (opposite the clip) has to lock onto a wire of the rear protection
grid (fig. 9). Then, each guidance jig on the frame ring has to lock onto the rear
protection grid. Therefore, you should push the frames toward each other with
your hand (fig. 10). At last, close the plastic clip (fig. 11) and fasten the screw
with a screwdriver. (Fig. 12)
10. Once the fan is properly assembled you can start using the appliance. (Fig. 13)
70
Fig. 13
Fig. 5 Fig. 6
Fig. 8
Fig. 9
Fig. 11
Fig. 7
Fig. 13
Fig. 10
Fig. 12
71