Dräger X-plore 6000 Notice D'utilisation page 83

After testing
1. Unscrew the test adapter.
2. Remove the facepiece from the test head and dry if necessary.
3. Fit the exhalation valve cover. It must click into place.
5 Transport
Transport the facepiece in a carrying box or mask bag.
6 Storage
Loosen the straps of the head harness as far as possible.

Wipe the visor with an antistatic cloth.

Make sure that the facepiece is dry.

Pack the facepiece in its bag or storage box.

Store the facepiece in a dry, dust-free place where it will not be deformed.

Keep the facepiece out of direct sunlight and heat.

Storage temperature: 5 °F to 77 °F (-15 °C to +25 °C).

Maximum storage temperature temporarily: 140 °F (+60 °C)
Observe ISO 2230 and national guidelines for storage, mainte-

nance and cleaning of rubber products.
Dräger rubber products are treated with an agent to protect against
premature aging which in some cases is visible as a gray-white
coating. This coating can be washed off with a brush and soapy water.
7 Disposal
Dispose of the facepiece and used canisters according to local waste
disposal regulations.
Dräger X-plore 6000 (Use Instructions for NIOSH-approved full facepieces)
Transport
83