Cutting - Metabo HPT CJ 110MV Instructions De Sécurité Et Mode D'emploi

English
13. Sub base (Sold separately)
Using the sub base (made from steel) will
reduce abrasion of aluminium base especially
in cutting metals.
Using the sub base (made from resin) will
reduce scratching of cut surface. Attach the sub
base to the bottom surface of base by attached
4 screws.
14. Lighting up the lamp
CAUTION: Do not look in the light or see the
source of light directly.
To turn on the lamp, pull the trigger.
Release the trigger to turn off.
NOTE: The lamp is connected to the main switch
and will be illuminated and extinguished
in accordance with the switch operations.

CUTTING

CAUTIONS:
In order to prevent blade dislodging, damage
or excessive wear on the Plunger, please make
sure to have surface of the base plate attached
to the work piece while sawing.
1. Rectilinear cutting
When cutting on a straight line, first draw a
marking gauge line and advance the saw along
that line. Using the guide (sold separately) will
make it possible to cut accurately on a straight
line.
(1) Loosen the base bolt allen wrench attached on
base. (Fig. 10)
(2) Move the base fully forward (Fig. 11), and
tighten the base bolt again.
(3) Attach the guide by passing it through the
attachment hole on the base and tighten the
M5 bolt. (Fig. 12)
(4) Set the orbital position to "0".
NOTE: To ensure accurate cutting when using the
Guide (Fig. 10), always set the orbital
position to "0".
10
Base
bolt
Allen wrench
Fig. 10
Base
Fig. 11
M5 bolt
Attachment
hole
Guide
Fig. 12
Base